1997 Plymouth Grand Voyager why Do Running and Tail Lights Continue to Blink After Removing Key
Q: My tail lights stay on even after car is off. The hazard lights and turning signals all work but the brake lights do not.
My tail lights stay on even after car is off. The hazard lights and turning signals all work but the brake lights do not.
My car has 120000 miles.
My car has an automatic transmission.
Recommended Services
If the tail lights are illuminated even after you have used the on-off switch to command them off, that means the switch supplying power is fused shut and/or the circuit is being powered when it is not supposed to be due to a wiring fault. To resolve an issue such as that, the circuit powering the lights has to be traced, starting with the devices that should indeed be "off" if commanded off (such as the light switch, relay, etc.). If the brake lights are not functioning, it is possible the filaments in both bulbs are burned out and that possibility should be ruled out first. If the bulbs are OK, the brake light switch and the rest of the circuit will have to be traced. If you want these steps performed by a certified Mechanic, dispatched by YourMechanic right to your location, please request an electrical circuit diagnostic and the responding certified mechanic will get this problem resolved for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Alternator went out; battery won't stay charged
I would first start with having your battery/starting system checked (https://www.yourmechanic.com/services/battery-will-not-hold-a-charge-inspection) by a certified technician. If the alternator turns out to be faulty, replacement will be required in order to get your vehicle in reliable running condition again. The technician...
Car won't charge
Hello! Since you have replaced the battery, we will put that to the side, but we cannot ignore it. A failed charging system puts a large load on a battery and can damage a new one, so I suggest having...
Crunching / cracking sound when turning sharp right at low speeds
The noise is most likely an outer axle joint (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-axle-cv-shaft-assembly). The joint that makes the noise when turning right will be the right or passenger side axle (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). If it was turning left and the noise happens then the noise...
P0306 code misfire
Hello there, many common faults will cause a cylinder 6 misfire in your 2001 Chevrolet Impala. The most common faults are the spark plugs, plug wires, fuel injectors, vacuum leak, fuel pump, or low cylinder compression. A qualified Technician such...
Transmission won't move
Be sure the wiring harness is connected to the transmission, although in drive the manual valve (in the transmission valve body) should at least get you into 1st gear. Check the fluid level. If fluid is really low, the transmission...
Why is it running hot? 1999 Mitsubishi Galant
Hello - it sounds like you may be experiencing a blown head gasket (https://www.yourmechanic.com/question/head-gasket-blown), or the radiator is clogged. Given that the radiator cooling fan is coming on, the thermostat, appears to be opening and the water pump is transferring...
05 acura tl wont crank till the third time trying?
If the problem occurred right after the service, there might be a connection. If the timing belt were not correct I would expect to see a check engine light, so that's probably not the case. But there might be a...
Related articles
How Long Does an Electronic Ignition Pickup Last?
Your Your vehicle depends on electricity in order to run, and this electricity can be traced back to the spark plugs which create a spark to ignite the fuel. It's a whole process, where each step depends on the other...
Browse other content
mccullendaylloween.blogspot.com
Source: https://www.yourmechanic.com/question/my-tail-lights-stay-on-even-after-car-is-off-the-hazard-lights-and-turning-signals-all-work-but-the-brake-lights-do-not-by-william-f
0 Response to "1997 Plymouth Grand Voyager why Do Running and Tail Lights Continue to Blink After Removing Key"
Post a Comment